Strainsert Standard Wiring Diagrams

Strainsert is pleased to provide products that range anywhere from the individual sensor itself all the way to complete turn-key systems. This allows the user to design his measurement system to meet his specific needs or they can purchase a complete functioning, tested and calibrated system, ready for immediate use with minimal set-up required. Typical turn-key solutions include the transducers, cabling, and read-out or signal conditioning instrumentation as appropriate.

The variety of force transducers and instrumentation systems are detailed in the product section. This section offers information on standard wiring diagrams for our strain gage transducers and the diagrams are displayed in the specification pop-ups below.

Full Bridge Connector Pin:

The specification wiring diagram includes the identification and cable color code and also the bridge trim and compensation resistors which are required at times.

SPECIFICATIONS (opens in pop-up window)

Full Bridge Connector Pin Specification Drawing and Table

Miniature Connector Full Bridge:

The specification wiring diagram includes the wiring/pin information for full bridge minature connectors.

SPECIFICATIONS (opens in pop-up window)

Miniature Connector Full Bridge Specification Drawing

Miniature Connector Quarter Bridge (3-Wire System):

This specification wiring diagram includes the wiring/pin information for quarter-bridge (3 wire systems).

SPECIFICATIONS (opens in pop-up window)

Miniature Connector Quarter Bridge Specification Drawing

Quarter Bridge Internal Strain Gage Installation:

This specification wiring diagram includes the identification and color code for 3-wire quarter bridge installations.

SPECIFICATIONS (opens in pop-up window)

Quarter Bridge Internal Strain Gage Installation Specification Drawing